Craftsman 580.752 owner manual €leaningtrace, Pressure Washer Rinsing

Applying Detergent with Adjustable Nozzle

IMPORTANT: Use chemicals designed specifically for pressure washers. Household detergents could

damage the pump.

CAUTION

To apply detergent, follow these steps:

1.Review use of adjustable nozzle.

2.Prepare detergent solution as required by job.

3.Place filter end of detergent siphoning tube into detergent container.

CAUTION

Imlm_mM_llgJm _'{'dil"[ttlim m _r_ Ira

/lIE IIEaiI/

',When inserting the fi!ter into a detergent solution bottle,

route the tube s0 as t0 keep it fr0m inadvertently c0nta_ing _e hot raUffler.

4.Slide adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in

high pressure position.

5.MaKe sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump. Start engine.

6.Apply detergent to a dry surface, starting from bottom and working up.

7.Allow detergent to =soak in" for 3-5 minutes before rinsing. Reapply as needed to prevent surface from drying.

8.For washing, start at lower portion of area to be washed and work upward, using long, even, overlapping strokes.

IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a clean bucket of water and running the pressure washer in low pressure for 1-2 minutes.

Pressure Washer Rinsing

For Rinsing:

1.Slide nozzle backward to high pressure, press trigger and wait for detergent to clear.

NOTE: You can also stop detergent flow by removing detergent siphoning tube from container.

2.Keep spray gun a safe distance from area you plan to spray.

WARNING

,Keep Sp!ayn_le b_een 8 t024 inches away from

€leaningtrace

,Operate this unit on a stable surface:

,Be extremely careful is you must use the pressure

washer from a !adderi scaffo!djng or any other relatively

.... Unstableiocatien........................................................

............ ......

Firrn!y graS#SpraygunWithb°th hands when us!nghigh

pressure spray to ayoid injury if gun kicks back.

3.Apply a high pressure spray to a small area, then check surface for damage. If no damage is found, it is okay to continue cleaning.

Start at top of area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.

Automatic Cool Down System

(Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125=F. The system engages to cool the pump by discharging the warm water onto

the ground.

10