How to Stop Your Pressure Washer
1.Move throttle lover to "Stop" position.
2.Squeeze trigger on spray gun to relieve pressure in hose,
NOTE: A small amount of water will squirt out when you release the pressure.
How To Use the Adjustable Nozzle
You now should Know how to START your pressure washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern and apply detergent or other cleaning chemicals.
CAUTION
•NEVER adjustspray pattern when spraying.
•NEVERput handsin front of nozzle toadjust sprayp_tern
On the end of your spray gun is a nozzle handle that can adjust the spray pressure and the spray pa_ern.
1.Point nozzle toward ground, disengage safety latch, and press trigger to l:est pa_ern.
2.Sliding nozzle forward and bacK adjusts spray pressure.
Siide nozziebackward | Slide nozzle f0P,_vatdfor I_ |
high pressurem0dei | p_essuremode and |
| detergent app!i_tion. |
3.Rotating nozzle adjusts spray pattern from a narrow pattern to a fan pattern.
Twist no>71e counter- | Twist nozzle ¢!o¢_ise for |
clockwise for fan Pattern | narrow spray pattern, |
4.For most effective cleaning, Keep spray nozzle
between 8 to 24 inches away from cleaning surface.
5.If you get spray nozzle too close, especially using high pressure mode, you may damage the surface being cleaned.
6.DO NOT get closer than 6 inches when cleaning tires.
Using the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a rapid circular pattern. The high pressure spray is most effective when the tip of the nozzle extension is held between 8 to 24 inches from the surface being cleaned.
CAUTION
hiddenarea.
To attach the turbo nozzle to the spray gun:
1, Engage safety latch to spray gun trigger,
2.Remove the nozzle extension from the spray gun, if attached.
3.Attach the turbo nozzle extension to spray gun.
_. Disengage safety latch to spray gun trigger.
5.Always start the turbo nozzle at a disl:anca, gradually getting closer to the surface until you get the cleaning force you want.
NOTE: Detergent cannot be applied with turbo nozzle.
9
