23
To Adjust Sail Switch
With the dryer operating at a high temperature setting, pull the sail switch away from the burner. The sail switch
should open and extinguish the burner. Let the sail switch damper return to the burner wall. The sail switch
should close to restart the burner ignition cycle. If the sail switch circuit does not operate as described, bend the
actuator arm of the sail switch accordingly until proper operation is achieved. To check proper “open” position of
sail switch, open main door, manually depress main door switch, and start dryer. With the main door open and the
dryer operating, the sail switch should be open, and the burner should not come on.

CAUTION: DO NOT abort this switch by taping or screwing sail switch damper to burner.

PERSONAL INJURY or FIRE COULD RESULT.

E. FRONT PANEL and MAIN DOOR ASSEMBLIESTo Replace Main Door Switch
1. Discontinue electrical power to the dryer.
2. Open main door.
3. Remove the two (2) Phillips head screws holding the main door switch
bracket assembly in place.
4. Remove door switch bracket from front panel and disconnect wiring
from switch.
5. Disassemble door switch from bracket by removing two (2) Phillips
screws and nuts securing on switch to the housing.
6. Reverse this procedure for installing new door switch.
7. Reestablish electrical power to the dryer.

IMPORTANT:UNDER NO CIRCUMSTANCES should the door switch be disabled.

To Replace Main Door Assembly
1. Remove screws holding top hinge block to front
panel.
2. Remove door by lifting up off of bottom hinge.
3. Reverse this procedure for reinstalling new main
door assembly.