Yourcleaningsystemrequiressomeassembly and is
ready for use only after it has been properly serviced
with the recommended oil andfuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oilwill result
in an engine failure.
REMOVE PRESSURE WASHERFROM CARTON
1. Open carton and slice two corners opposite guide
handle from top to bottom sothe panel can be
folded down flat.
2. Remove hose reel box, fillers, and parts bag
shipped with cleaning system.
3. Remove spray gun, nozzle extension, and engine
oil from fillers.
4. Roll cleaning system out open end ofcarton.
5. Raise guide handle, secure in place.
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 5. Ifany parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1. Attach hose reel.
2. Add oilto engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and pump.
5. Connect water supply to pump.
Assembling Hose Reel
Obtain 14ram and 10ram open end wrenches and a #2
phillipsscrewdriver.
1. Attach handle to reel with Iocknuts, flatwashers,
and bolts as shown.
M6 Screws
Handle
Lift handle toUpright position
ands!ide locking capsinto
place
6. Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any partsare missing or
damaged, call the pressurewasher helpline at
1-800-222-3136.
Main unit -- cleaning system withwheels, chemical
tanks, guide handle
Hose reel components
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Engine oil
Parts bag (which includes items listed below)
Three-pack of chemical concentrates
Owner's manual
Maintenance kit
Tank labels
Registration card
M6 Locknuts
Flatwashers
2. Secure hose reel to left side upright with Iocknuts
and bolts.
mounts
,through slot
. on panel

/