Craftsman 580.76804 manual Aii J\I, RINSE sYSTEM AFTER EVERY USE, Wash and Rinse Surface

Connect garden hose to water inlet (see TO START CLEANING SYSTEM on page 8), check

that high pressure hose is connected to spray gun

and pump (see ASSEMBLY on page 4), and start engine,

Hose Here " 'AII J\I

Connect Garden

__i]

After you have applied detergent, scour the surface with the high pressure water stream and then rinse it

clean, as follows:

Pull adjustable nozzle backward until it snaps to get high pressure mode. Chemical will not flow when in

the high pressure mode.

desiredAdjustPressUrewaterpressure.C°mmandTacontrol to obtain

action. Start at top of area to be rinsed, working down with same action as for cleaning.

CAUTION! Test a small area of the surface to

Expandbe cleanedthe spray. Makepattamsuref°rtherea m°reis nogentledamagednsing caused by the high pressure spray.

ASystem,CAUTION!makeBeforesure youstartinghaveyourreadCleaningandfollowed the instructions in the sections "Before Starting the Cleaning System" on page 8 and =To Start the Cleaning System" on page 8.

AWARNING!usethecleaningBe extremelysystemfromcarefulladder,ifyou must scaffolding or any other relatively unstable location. When you press the trigger, the recoil from the initial spray could rome you to fall, or if you are too close to the cleaning surface, high pressure could force you off a climbing apparatus.

•Start at lower portion of area to be washed and work upward, using long, even overlapping strokes.

•Allow detergent to 'soakin'(between 3-5 minutes) before washing and rinsing. Reapply as needed to prevent surface from drying.

Wash and Rinse Surface

This Craftsman Cleaning System permits regulation of output water pressure by varying the engine speed. The Pressure Command TM found on the front panel

may be set, as follows.'.
Pressure	Low	to	High
Duty	Ught	Medium	Heavy
Application	Auto	Concrete	Paint removal
	Boat	Driveway	Degreasing
	Furniture	Deck

RINSE sYSTEM AFTER EVERY USE

It is imperative that the chemical selector system be rinsed after'each use to prevent clogging or leaks:

•Fill the System Rinse reservoir with clean water.

•Before disconnecting the water supply, start your cleaning system.

,&CAUTION! Before starting your Cleaning System, make sure you have read and followed the instructions in the sections =Before Starting the Cleaning System" on page 8 and =To Start the Cleaning System" on page 8.

Push adjustable nozzle forward to get low pressure mode.

Rotate the Dial-A-Cleaner TM selector knob to the letter corresponding to the System Rinse tank. As clean rinse water is drawn through the system, continue the flow until no detergent foam is observed.

Rotate the Dial-A-Cleaner TM selector knob to the

OFF position.

7