blades are dull and need to be sharpened or replaced. To sharpen or replace the blades, refer to
Service and Adjustments section.
IMPORTANT: There is a flail screen located inside the housing in the discharge area. If the flail screen becomes clogged, remove and clean as instructed in the Service and Adjustments section on page 14.
TO LOWER THE HOPPER
ASSEMBLY
•To lower the hopper assembly, use one hand to grasp the
•Pull up on the release bar, and lower the hopper assembly to the ground. Release the bar. Refer to figure 5.
WARNING: The
Shred material upto 112 inch in diameter
\
GENERAL RECOMMENDATIONS
•Always observe safety rules when performing any maintenance.
•The warranty on this chipper shredder does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the
•Some adjustments will be needed periodically for proper maintenance of your chipper shredder.
These adjustments are covered in the following section of this manual.
•All adjustments mentioned here should be checked at least once each season.
•Follow the maintenance schedule given below.
Figure 13
Periodically check all fasteners and make sure these are tight.
CLEANING
•Clean the
•Wash the bag periodically with water. Allow to dry thoroughly in the shade. Do not use heat.
WARNING: Always stop the engine and disconnect the spark plug wire before performing any maintenance or adjustments.
Never remove discharge chute tillthe engine has completely stopped.
11
