STOPPING YOUR UNIT
Slide the ON/OFF switch to the OFF _£1sition.A.
RTING YOUR UNIT
Your unit has two run positions, LOW and HIGH. Slide the switch to one of
these positions to turn on the unit.
_iIkWARNING: | Do not use the unit |
without the tubes or collection bag properly attached to avoid flying debris and/or impeller contact which can cause serious injury. Always wear eye protection to prevent rocks or debris from being blown or ricocheting into the eyes and face which can result in blindness or serious injury.
OPERATING POSITION
Eye Protection | Eye Protection |
rVacuum
USING YOUR UNIT AS A BLOWER
4_.I!bWARNING: Inspect the area be-
fore using the unit. Remove all debris and hard objects such as rocks, glass, wire, etc., that can ricochet, be thrown, or otherwise cause injury or damage during operation.
Use your unit as a blower for:
•Sweeping debris or grass clippings from driveways, sidewalks, patios, etc.
•Blowing grass clippings, straw, or leaves into piles, or removing debris from corners, around joints, or be- tween bricks.
Direct air flow by directing the blower tube down or to one side. Always work away from solid ob ects such as walks, large stones, vehicles, and fences. Clean corners by starting in corners and moving outward. This will help prevent an accumulation of debris which could fly into your face.
Be careful when working near plants. The force of the air could damage tender plants.
USING YOUR UNIT AS A VACUUM
_lk WARNING: Do not vacuum
stones, gravel, metal, broken glass, etc., to avoid severe damage to the im- peller. To avoid the possibility of elec-
trical shock, do not attempt to vacuum water or other liquids.
Use your unit as a vacuum to pick up dry material such as leaves, grass, small twigs, and bits of paper.
•For best results during vacuum use, operate your unit at high speed.
•Move slowly back and forth over the material as you vacuum. Avoid forc- ing the unit into a pile of debris as this can clog the unit.
•Keep the vacuum tube about an inch above the ground for best results.
_WARNING: | If the unit becomes |
clogged, stop the unit and unplug the extension cord. Wait until the impeller has completely stopped turning, then remove the vacuum tubes. Carefully reach into the vacuum opening and clear out the clogged debris.
CUSTOMER RESPONSIBILITIES
WARNING: Disconnect power source before performing maintenance.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts Check for damaged or worn parts Inspect and clean unit and labels Remove and empty collection bag Clean collection bag
WHEN TO PERFORM
Before each use
Before each use
After each use
After each use
Yearly
9