Craftsman 900.370520 manual To Charge Battery, • While holding the finger gdp up, you _an

CHARGING BATTERY

Although your mower battery was fully charged when it left the factory, it is nec- essary to recharge it before initial use. This will ensure that the battery operates at full performance capability.

There are two charge Indicator lights on your mower. The red light (1) glows while the battery is charging. The green light (2) glows when the battery is fully charged. During the mowing season, plug the charger into mower whenever mower is not being used.

Safety Key

To prevent accidental start-up or unautho- rized use, your mower has a removable Safety Key (3). The mower will not oper- ate when the Safety Key is removed. The Safety Key has a hole in its center to allow for storage on a nail, out of the reach of children.

CAUTION: Always remove Safety Key from mower when leavingmower unat- tended, even for a short period of time.

To Charge Battery

•Remove safety key (3).

•Plug the charger cord (4) into the recep- tacle (5) on the mower. The charger cord plug has a retaining clip (6) which wilt lock the plug into the mower while charging to avoid accidental removal.

•Insert the 120 volt plug (7) of the charg- er (8) into the wall receptacle.

•The red light on the mower should come on Indicating you have power and the battery Is being charged. The red light should extinguish and the green light Gome on when oharglng is complete. It takes approximately 24 hours to cherge s fully dls0harged battery,

For opllmun_ pert_]tm_mce during the mowing season, always connect the mower to the charger when mower is not in use.

•To remove the plug from the mower, press retaining clip (6) firmly in the direction of the arrow and pull plug from charging receptacle on mower.

TO ADJUST CUTTING HEIGHT

(1-1/2" TO 3-1/2")

CAUTION: Before making any adjust- ments, release switch to turn mower off, wait for blade to stop, and remove safety key.

•Your mower features a "one touch" wheel height adjustment system. This system adjusts all four wheels at the same time.

•To raise or lower the cutting height, place the palm of your hand on the palm rest

(1)and with your fingers squeeze upward.on the finger grip (2) and hold. (See Fig. A)

• While holding the finger gdp up, you _an

raise or lower the cutting height. The

mower has seven cutting height posi- tions. They are indicated by the scale

(1)and pointer (2) at the front of the mower. (See Fig. B)

•When you have the mower at the height