Weslo WLTL01530 user manual Insert two batteries into the two battery clips, Tab

5.Hold the Handrail (5) near the Left and Right Uprights (35, 36). Connect the Handrail Wire (2) to the Reed Switch

Wire (6). Insert the Wires down into the Left Upright.

Attach the Handrail (5) to the Uprights (35, 36) with four

M8 x 15mm Bolts (33) and four M8 Washers (34).Be careful not to pinch the Wires (2, 6).

6.The Console (1) requires two “AAA” batteries. Alkaline batteries are recommended. Press the indicated tab on the Battery Cover (27) and remove the Battery Cover.

Insert two batteries into the two battery clips;	make sure
that the negative (–) ends of the batteries are touch-
ing the springs in the battery clips.

7.See drawing 7a. Hold the Console (1) near the Handrail

(5). Connect the wire on the Console to the Handrail

Wire (2). Attach the Console to the Handrail with two M4

x 12mm Screws (3). Make sure that the wires are not pinched.

See drawing 7b. Press the Battery Cover (27) back onto the Console (1).

8.Remove the paper backing from the Adhesive Clip (30). Press the Adhesive Clip onto the left side of the Frame

(29)in the indicated location. Press the Allen Wrench

(20)into the Adhesive Clip.

Make sure that the walking belt is properly tightened (see SYMPTOM 3 on page 8).

9.Make sure that all parts are properly tightened before you use the treadmill. place a mat under the treadmill.

5

5	33	34
			5
		2
		6
		35	34
			33
			36
6
Batteries
		1
			Tab
		27
7a		1	7b
			1
		2
		5	27
		3
8
		20
			30

29

To protect the floor or carpet,