ASSEMBLY
The help of a second | person is recommended. | Set the treadmill in a cleared area and remove all packing | |
materials. Do not dispose of the packing materials until assembly is completed. | Assembly requires only the | ||
included allen wrench | and wrench | . |
|
1.Identify the Right Upright (36), which has a single hole in the indicated location. Hold the Right Upright against the Base (14) as shown, and orient the Right Upright so the two indicated holes are on the side shown.
Attach the Right Upright (36) to the Base (14) with two M8 x 50mm Bolts (38), two M8 Curved Washers (37),
and two M8 Nylon Nuts (13) as shown.
Attach the Left Upright (35) to the Base (14) in the same way. Make sure that the Left Upright is oriented so the
two indicated holes are on the side shown.
2.Raise the Left Upright (35) and the Right Upright (36) to the position shown. Feed the Reed Switch Wire (6) into
the top of the Left Upright and out of the indicated hole.
3.Attach the Hood (28) to the front of the Frame (29) with two M5 x 10mm Bolts (10).
4.See drawing 4a. Hold the front of the Frame (29)
between the Left Upright (35) and the Right Upright (not shown). Align the holes near the front of the Frame with one of the three sets of adjustment holes in the Uprights. Insert a Pin (4) into each Upright and each side of the Frame. Make sure that the Pins are fully inserted at
the same height.
Look under the Frame (29) near the Left Upright (35). See drawing 4b. Locate the Clip (11) attached to the underside of the Frame. Insert the Reed Switch (6) into the Clip as shown. Next, locate the Magnet (12) on the left Flywheel (9). Turn the Flywheel until the Magnet is
aligned with the Reed Switch. Move the Reed Switch so that there is a 1/8” gap between the Reed Switch
and the Magnet. Then, tighten the M4 x 12mm Screw
(3) in the Clip.
1 |
| Holes |
|
|
| 36 |
|
|
|
|
|
| Hole |
|
37 |
| 14 |
|
|
38 |
| Holes |
| |
|
|
| ||
| 13 |
| 35 |
|
| 37 | 37 |
|
|
|
| 13 |
| |
|
|
|
| |
| 38 |
|
|
|
|
|
| 37 |
|
2 | 6 |
|
|
|
|
| 36 |
| |
| 35 |
|
|
|
| Hole |
|
| |
3 |
|
|
|
|
| 10 | 28 |
|
|
|
|
|
| |
|
|
|
| 29 |
|
|
|
| 10 |
4a | 35 | 4b | 9 |
|
|
|
| ||
| 4 |
|
|
|
|
|
| 3 | 11 |
29 |
| 12 | 6 | |
|
|
|
| |
|
|
| 1/8” |
|
|
|
| View from | 29 |
|
|
| below |
|
4