MAINTENANCE AND TROUBLESHOOTING
Most problems can be solved by following the simple steps below. If further assistance is needed, call
our Customer Service Department
1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY
a.Replace the batteries in the console (see assem- bly step 6 on page 5).
b.Make sure that the reed switch is properly adjust- ed (see assembly step 4 on page 4).
c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 7 on page 5).
d.The console, like most electronics, is susceptible
to static electricity
types of clothing or by the operation of the tread- mill. If the display is blank or gives incorrect read-
ings, apply an
2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY
a. If the walk- |
| |
ing belt is | Walking Belt | |
overtight- | ||
| ||
ened, per- |
| |
formance |
| |
may be |
| |
reduced and |
| |
the walking |
| |
belt may be | ||
permanently | ||
| ||
damaged. | Bolts | |
Using the | ||
| ||
allen |
|
wrench, turn both rear roller adjustment bolts |
|
counterclockwise 1/4 of a turn. When the tension |
|
of the walking belt is correct, you should be able |
|
to lift each side of the walking belt 2 to 3 inches. |
|
Walk on the treadmill for a few minutes. R | epeat |
until the walking belt is properly tightened. Be |
|
careful to keep the walking belt centered. |
|
3.SYMPTOM: THE WALKING BELT SLIPS OR IS
a.If the walking belt slips
when walked
on , use the
allen wrench to turn both adjustment
bolts clockwise,
1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 2 to 3 inches. Walk on the tread- mill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centered.
b.If the walking belt has shift- ed to the left
side , use the
allen wrench to turn the left adjustment bolt
clockwise, and
the right adjustment bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.
c.If the walking
belt has shift- ed to the right side , use the
allen wrench to turn the left adjustment bolt
counterclock-
wise, and the right adjustment bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.
8
