Craftsman 900.370520 manual aged return mower to a Sears Service Center, lever Is activated

TROUBLESHOOTING GUIDE

PROBLEMSOLUTION

Mower doesn't run when switch

lever Is activated.

Motor stops while mowing.

,Check to make sure safety key has been installed and Is fully seated.

2.Remove safety key, turn mower over and check that blade is free to turn.

3.Has battery been fully charged? Plug in charger and wait for green light to come on.

1.Remove Safety Key. Turn mower over and check that blade is free to turn.

2.Raise cutting height of wheels to highest position and start mower.

3.Has battery been fully charged? Plug in charger and wait for green light to come on.

4.Circuit breaker may have tripped. It resets automatically. Re-set time could be as long as 1 minute. Slow down or raise cut height.

Mower runs but cutting perfor-

mance Is unsatisfactory,or does not cut your entire lawn.

Mower is too hard to push.

Mower is abnormally noisy and

vibrates.

1.Has battery been fully charged? Plug in charger and wait for green light to come on.

2.Remove Safety Key. Turn mower over and check:

*Blade for sharpness

*Deck and discharge chute for clogging.

3.Wheel height adjustment may be set too low for grass condition. Raise cuttingheight,

1.Raise cutting height to reduce deck drag on grass. Check each wheel for free rotation.

1.Remove Safety Key. Turn mower on side and check blade to ensure It has not been bent or damaged. If blade is damaged, replace with a Craftsman replacement blade, If the underside of the deck is dam-

aged return mower to a Sears Service Center.

2.If there is no visible damage to the blade and the mower still vibrates, return the mower to a Sears Service Center.