ASSEMBLY INSTRUCTIONS
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):
- Phillips Screwdriver
ATTACHING THE TWO PIECE GUARD
WARNING: UNPLUG THE TOOL BEFORE ATTEMPTING TO ATTACH THE GUARD. NEVER OPERATE TOOL WITHOUT GUARD FIRMLY IN PLACE. THE GUARD MUST ALWAYS BE ON THE TOOL TO PROTECT THE USER.
•Remove the two guard sections from the carton.
•Attach the first guard section with side tab into the groove around the housing as shown in figure 1. Align the hole in the guard with the post on the trimmer housing.
1
Tab
•Remove the screw from the second guard section.
•Insert the top tab from the second guard section into the first guard section as shown in figure 2. NOTE:
The rib behind the tab should be hooked over the rib of the first guard section. (See inset figure 2).
2 |
Tab |
Rib |
5
•Insert the side tab from the first guard section into the slot of the second guard section until you hear them “snap” together (figure 3).
3 |
Slot |
Tab |
•Insert the 3/4 inch (19mm) screw as shown in figure 4 to complete the guard assembly.
4
•Once the guard is installed, remove the covering from the line
ATTACHING THE AUXILIARY HANDLE
•Attach the handle to the metal shaft of the trimmer by pushing it onto the shaft from the side. Once it is pushed onto the metal shaft, the handle can be turned into the correct orientation.
•Insert the
