Craftsman C935.51850 manual Operating Instructions, Switching On And Off, Blower Function Figure

OPERATING INSTRUCTIONS

WARNING: Always use proper eye protection that conforms to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.

CAUTION: Inspect area to be trimmed and remove any wire, cord, or string-like objects which could become entangled in the rotating line or spool. Be particularly careful to avoid any wire which might be bent outwardly into the path of the tool, such as barbs at the base of a chain link fence.

SWITCHING ON AND OFF

•To switch the tool on, squeeze the trigger lever.

•To switch the tool off, release the trigger lever.

•With the unit on, angle unit and slowly swing the trimmer side to side as shown in figure 8.

8

•To operate as a maintenance edger, unplug the unit from the power source. Push the conversion button and rotate the tube 180° as shown in figure 6. The tool will lock in position. Gently pull the wire edge guide down into place as shown in figure 9 and position the trimmer above the surface as shown in figure 9.

•Return to the trimming position by unplugging the unit from the power source, pushing the conversion button and rotating the tube back 180°. The tool will lock in the trimmer position. When using the tool return the wire edge guide to the original position, out of the way.

9

BLOWER FUNCTION (FIGURE 10)

The air flow created by the motor funnels up through the guard to provide a built-in blower. This feature can be used to blow grass clippings off of sidewalks and other hard surface areas.

10

CUTTING LINE / LINE FEEDING

Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding line hub will automatically feed and trim a fresh length of line. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut. The

7