Craftsman C935.51850, 900.74547 manual Accessories, Maintenancetroubleshooting, Tool runs slowly

14

	j
k	k

•Repeat the above procedure for the second cutting line on the lower section of the spool.

•Fit the spool onto the tool as described in “FITTING A NEW SPOOL OF CUTTING LINE”.

CAUTION: Before you begin trimming, only use the appropriate type of cutting line. Ensure that cutting line is present in both sections of the spool (figure 12).

2.Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.

3.Plastic parts may be cleaned by using a mild soap and a damp rag.

4.The line cutter on the edge of the guard can dull over time. It is recommended you periodically touch-up the sharpness of the blade with a file.

ACCESSORIES

Use Craftsman replacement spool Model No. 85942.

Reload nylon line (either bulk or prewound replacement spool) as described in this manual.

•USE ONLY .065 inch (1.65 mm)

DIAMETER NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. The unit only functions properly with .065 inch (1.65 mm) diameter nylon monofilament line. This line is available at your local Sears store or other Craftsman outlet.

WARNING: The use of any accessory not recommended by Sears for use with this tool could be hazardous.

MAINTENANCETROUBLESHOOTING

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by a Sears or other qualified service dealer, always using identical replacement parts.

WARNING: To avoid serious injury, switch off and unplug the tool before performing any maintenance.

1.Keep the air intake slots (figure 15) clean to avoid overheating.

15

9

WARNING: To avoid serious injury, switch off and unplug the tool before performing any maintenance.

Tool runs slowly

•Check that the cassette housing can rotate freely. Carefully clean it if necessary.

•Check that the cutting line does not protrude more than approximately 4-3/8 inches (111mm) from the cassette. If it does, cut it off so that it just reaches the line trimming blade.

Automatic line feed does not work

•Keep the tabs depressed and remove the cassette from the cassette housing in the trimmer head.

•Pull the cutting line until it protrudes approximately 4-3/8 inches (111mm) from the cassette. If insufficient cutting line is left on the spool, install a new spool of cutting line.

•Align the tabs on the cassette with the cut outs in the housing.

•Push the cassette onto the housing until it snaps securely into place.

•If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade.