SERVICE AN
TO ADJUST STEERING WHEEL ALIGNMENT
if steering wheel crossbars are not horizontal (left to right) when wheeis are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.
FRONT WHEEL TOE-INICAMBER
The front wheet
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 27)
oBlock up axle securely.
=Remove axle cover, retaining ring and washers to aflow wheel removal (rear wheel contains a square key - Do not lose).
o Repair tire and reassemble_
°On rear wheels only: align grooves in rear wheel hub and axle. Insert square key,,
. Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
WASHERS
RETAINING
RING
AXLE COVER
(REARWHEELONLY)
FIG_27
ADJUSTMENTS
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 28)
CAUTION;
and smoking materials away from bat- I ate explosive gases. Keep sparks, flame teries. Always wear eye protection
when around batteries.
your battery is too weak to start the engine, it should be
recharged.. If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES
TO ATTACH JUMPER CABLES -
. Connect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis.,
°Connect one end of the BLACK cable to the NEGA- TIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tankand battery.
TO REMOVE CABLES, REVERSE ORDER -
oBLACK cable first from chassis and then from the fully charged battery
o RED cable last from both batteries,
"POSITIVE" (+) |
PANEL
BOLT
FIG. 28
22
