Craftsman 917.25552 Tools Required for Assembly, To Remove Unit from Carton, Unpack Carton

ASSEM

ii iii iii, u.,

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier Standard wrench sizes are listed,

(1)	5/16" wrench	(1)	3/4" wrench
(2)	7118" wrenches	Tire	pressure gauge
(1)	1/2" wrench	Screwdriver
(1)	9/16" wrench	Utility knife

LY

INSERT

1t

2-1/4" DIA, WASHER

When right and left hand is mentioned in this manual, it means when you are in the operating position (seated be- hind the steering wheel),

TO REMOVE UNIT FROM CARTON

UNPACK CARTON

•Remove all toose parts from carton (See page 6)

•Cut, from top to bottom, all four corners of carton and lay panels flat

STEERING BUSHING

STEERING BOOT

ATTACH STEERING WHEEL (See Fig. 1)

•Sfide the steering bushing over the steering shaft

•Raise steering shaft forward until screw holes in dash line up with steering bushing. Install two (2) sh@t

	metal screws and tighten securely	\
•	Position steering boot over steering shaft	\

•Place tabs of steering boot over slots in dash and push',k down to secure

•Slide steering wheel adapter onto upper steering shaft

•Position front wheels of the tractor so they are pointing straight forward

•Position steering wheel so cross bars are horizontal//

(left to right) and slide onto adapter /

,Assemble large flat washer and 1/2-20 hex nut ar_tJ tighten securely

•Snap insert into center of steering wheel

•Remove protective plastic from tractor hood

BEFORE ROLLING UNIT OFF SKID

(See Fig. 6)

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES 1N SKID THAT MAY PUNC-

TURE TIRES WHERE UNIT IS TO ROLL OFF SKID.

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Roll unit backwards off skid

STEERING SHAFT (SHIPPING

POSITION)

STEERING SHAFT

(ASS EMBLY POSITION)

FIG, 1

7