.ll.".....n..u | . | i_ I_ | u | lurnl.u....i.n n . |
TROUBLESHOOTBNG POINTS
,,p.l,.i | .........i. | i.......i | i.. | '' i |
PROBLEM | CAUSE |
|
|
| ||
|
|
|
| i | i,,,,,,ll,,,i,,, i,,,n, ,, | |
Engine conUnues | to run | Faulty | presence control system. | |||
when | operator leaves seat |
|
|
|
| |
with | attachment | clutch |
|
|
|
|
engaged |
|
|
|
|
| |
| 1. | Worn, bent | orloose | blade, | ||
|
| 2. | Mower | deck | not level. | |
3, Buildup of grass, leaves, and trash under mower.
4.Bent blade mandrel.
5.Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels.
CORRECTION
1.Check wiring, switches and connections. I1not corrected, contact Sears Service Center/Department.
1.Replace blade. Tighten blade boil
2.Level mower deck,
3.Clean underside of mower housing°
4Replace blade mandrel.
5, Clean around mandrels to open vent hotes_
Mower bladeswlll not rotate
Poor grass discharge
1.Obstruction in clutch mechanism.
2.Wain/damaged mowerdnve belt, 3, Frozen idler pulley
4, Frozen blade mandrel
tEngine speed too slow
2o Travel speed too fast
3.Wet grass
4, Mower deck not level
5, Low/uneven tire air pressure
6Worn, bent or loose blade
7Buttdup of grass, leaves and trash under mower.
8,. Mower dr;ve belt worn,
9Blades improperly instafled,
10 improper blades used
t 1. Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels.
1, Remove obstruction_
2.Replace mower drive belt.
3Replace idler pulley.
4.Replace blade mandrel,
1 Race threlt[e control in "FAST" position.
2.Shift to slower speed.
&Allow grass to dry before mowing.
4 Level mower deck,
5 Check tires for proper air pressure.
6 Rep]acetsharpen blade, Tighten blade bolt.
7 Clean underside of mower housing.
8.Replace mower drive bell
9.Reinstall blades sharp edge down.
10.Replace with blades listed in this manual.
11, Clean around mandrels to open vent holes.
Headlight(s) not worldng | 1. | Switch | is "OFF". |
(if so equipped) | 2. | Bulb(s) | bumedout. |
| & | Faulty | light SwitCh,r |
| 4. | Loose | or damaged wiring |
| 5, | Blown | fuse. |
,n,,,,ull=,,,,,,, i , | , |
|
|
1 "rum switch "ON",
2.Replace bulb(s),
3Checldrepiace light switch,
4.Check wiring and connections.
5.Replace fuse.
Battery willnot charge
Engine "backfires" when turning engine
"OFF"
1 Bad battery ceil(s)
2, Poor cable connections
3.Faulty regulator (if so equipped).
4.Faulty alternator
Engine throttle control not set at "SLOW' posilion for 30 seconds before stopping engine,
1, Replace battery.
2.Check/clean all connection&
3Replace regulator, 4, Replace alternator,
Move throttle control to 'SLOW'positionand allow toidle for30 seconds belore stepping engine_
26
