RVICE AND ADJUSTMENTS
ill | ill | ii | i | i | i |
FRONT WHEEL TOE-IN ADJUSTMENT
Front wheel
TO CHECK
=Position front wheels straight ahead.
•Measure distance between wheels at front and rear of tires (dimensions "A" and "B").
=Front dimension "A" should be 1/8" to 1/4" less than rear dimension "B",,
TO ADJUST
-Loosen jam nuts at adjustment sleeves on tie rod°
oAdjust tie rod until dimension"A" is 1/8" to 1/4" less than dimension "B".
oTighten jam nuts securely.
_A_
FIG. 28
ADJUSTMENT
SLEEVES
JAM NUTS _'_ | _ |
TIE ROD
FIG. 29
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractoro if damage has occurred to affect the front wheel camber, contact your nearest authorized service center/depart- ment,,
..................
WAS1
RETAINING
RING
AXLE
COVER
FIG. 30
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local
parts dealer.. Tire sealant also prevents tire dry rot and corrosion°
TO START ENGINE WITH A WEAK BATTERY (See Fig. 31)
CAUTION: Lead-aci"d"'b'atteriesgen'er':.....
and smoking materials away from bat- ateexpiosivegases. Keepsparks, flame teries. Always wear eye protection when around batteries,
LL/lll.l,,J.Jl/llJllll. Illll I I | I | HI |
If your battery is too weak to start the engine, it should be
recharged° If "jumper cables" are used for emergency starting, folrow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WiTH A I2 VOLT NEGATIVE GROUNDED SYSTEM., THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES°
TO ATTACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGA- TIVE
°Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tankand battery,,
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries_
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig,,30) - | "POSITIVE" {+) | "NEGATIVE" | |
° | Block up axle securely. |
|
|
. | Remove axle cover, retaining ring and washersto allow |
| LH. PANEL |
| wheel removal. |
| LT |
°Repair tire and reassemble°
• | Replace | washers and snap reta{ning ring securely in | .................// |
| axle groove. | ||
|
| ||
° | Replace | axle cover_ |
|
REAR WHEEL - |
|
- | Block rear axle securely, | FIG. 31 | |
° | Remove five (5) hub bolts to allow wheel removal | ||
|
•Repair tire and reassemble, Replace and tighten hub
bolts securely. | 25 |
|