Craftsman 917.27066 Towing Carts and Other Attachments, To Operate Mower, To Operate on Hills

Models: 917.27066

1 60
Download 60 pages 52.95 Kb
Page 14
Image 14

ing hot months. For healthier and better

looking lawns, mow often and after

moderate growth.

For best cutting performance, grass

over 6 inches in height should be mowed twice. Make the first cut rela-

tively high; the second to desired

height.

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

Select desired height of cut.

Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES - disen-

A_lLgage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the discharge guard in place.

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15 ° and do not drive across any slope. Use the slope guide provided at the back of this manual•

Choose the slowest speed before starting up or down hills.

Avoid stopping or changing speed on hills.

If slowing is necessary, move throttle control lever to slower position.

If stopping is absolutely necessary, push clutch/brake pedal quickly to

brake position and engage parking brake.

Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is de-

pressed.

 

 

 

Attachment Clutch

 

Attachment Lift

Lever "Engaged_--_

 

Lever High Position

Position

__.

 

 

 

 

+':_'+

*'Dlsengaged-_--_,v//'=,]l

} ._,::"L"Low Position

Position

t. __

.._:-'_

 

 

 

,_"

DiS3hdrge

To restart movement, slowly release parking brake and clutch/brake pedal.

Slowly move motion control lever to slowest setting.

Make all turns slowly.

TO TRANSPORT

When pushing or towing your tractor, be sure to disengage transmission by

placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

Raise attachment lift to highest position with attachment lift control.

Pull freewheel control out and down into the slot and release so it is held in the disengaged position.

Do not push or tow tractor at more than two (2) MPH.

To reengage transmission, reverse above procedure.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord,

etc.).

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing.

Too heavy of a load, while on a slope, is dangerous. _res can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw

cap tight, wait for a few seconds, remove and read oil level. If necessary,

add oil until "FULL" mark on dipstick is reached. Do not overfill.

14

Page 14
Image 14
Craftsman 917.27066 owner manual Towing Carts and Other Attachments, To Operate Mower, To Operate on Hills, To Transport