PURGE TRANSMISSION
_ILCAUTION: Never engage or disen- gage freewheel lever while the engine is running.
To ensure proper operation and perfor- mance, it is recommended that the trans- mission be purged before operating trac- tor for the first time. This procedure will re- move any trapped air inside the transmis- sion which may have developed during shipping of your tractor.
IMPORTANT: Should your transmission require removal for service or replace- ment, it should be purged after reinstalla- tion before operating the tractor.
•Place tractor safely on level surface with engine off and parking brake set.
•Disengage transmission by placing freewheel control in freewheeling posi- tion (See "TO TRANSPORT" in this sec- tion of manual).
•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) posi- tion, slowly disengage clutch/brake pedal.
•Move motion control lever to full for- ward position and hold for five (5) sec-
onds. Move lever to full reverse position and hold for five (5) seconds. Repeat this procedure three (3) times.
NOTE: During this procedure there will be no movement of drive wheels. The air
is being removed from hydraulic drive system.
•Move motion control lever to neutral (N) position. Shut off engine and set park- ing brake.
•Engage transmission by placing free- wheel control in driving position (See
'TO TRANSPORT" in this section of manual).
•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. With motion control lever in neutral (N) posi- tion, slowly disengage clutch/brake pedal.
•Slowly move motion control lever for- ward; after the tractor moves approxi- mately five (5) feet, slowly move motion control lever to reverse position. After the tractor moves approximately five (5) feet return the motion control lever to the neutral (N) position. Repeat this
procedure with the motion control lever
three (3) times.
•Your tractor is now purged and ready for normal operation.
MOWING TIPS
•Tire chains cannot be used when the mower housing is attached to tractor.
•Mower should be properly leveled for
best mowing performance. See "TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
•The left hand side of mower should be used for trimming.
•Drive so that clippings are discharged onto the area that has been cut. Have
the cut area to the right of the tractor. This will result in a more even distribu-
tion of clippings and more uniform cutting.
•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished.
•If grass is extremely tall, it should be mowed twice to reduce load and
possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.
•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.
•Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of material. Regulate ground speed by selecting a low enough gear to give the mower the best cutting performance as well as the quality of cut desired.
•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.
16
