![](/images/new-backgrounds/1097047/9704751x1.webp)
TO A'I-FACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-
tery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE OR- DER -
BLACK cable first from chassis and then from the fully charged battery.
•Red cable last from both batteries.
Positive Terminal Negative Terminal
Baffery
Positive Terminal | Negative Terminal |
REPLACING BATTERY
_, CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, re- move metal bracelets, wristwatch bands,rings,etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
•Lift seat pan to raised position and open battery box door.
Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
•Install new battery with terminals in same position as old battery.
•First connect RED battery cable to posi- tive (+) terminal with hex bolt and keps nut as shown. Tighten securely.
•Connect BLACK grounding cable to negative
•Close battery box door.
Seat Pan
Battery
Door Box
Keps
Bolt
Positive (Red) Cable Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring dia- gram in the Repair Parts section.
TO REPLACE FUSE
Replace with 15 amp
26