Craftsman 917.270732 To Replace Headlight Bulb, To Remove Hoodand Grill Assembly, Engine

REPLACING BATTERY

ACAUTION: Do not shod battery terminals by allowing a wrench or any other object to contact both terminals at

the same time. Before connecting battery, remove metal bracelets, wristwatch

bands,rings,etc.

Positive terminal must be connected first to prevent sparking from accidental

grounding.

•Lift seat pan to raised position and open battery box door.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

•Close battery box door.

Seat Pan

Battery

Door

Box

Keps

NutHex

Positive (Red)	Negative (Black)
Cable	Cable

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 15 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOODAND GRILL ASSEMBLY

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

Headlight Wire

Connector

ENGINE

Maintenance, repair, or replacement of the emission control devices and

systems, which are being done at the customers expense, may be performed by any non-road engine repair establish- ment or individual. Warranty repairs must

be performed by an authorized engine manufacturer's service outlet.

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttle control lever from slow to choke

position. Slowly move lever from choke to fast position.

24