9

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from
the shipping container(s). Remove the protective coating
from all unpainted surfaces. This coating may be removed
with a soft cloth moistened with kerosene (do not use
acetone, gasoline or lacquer thinner for this purpose). After
cleaning, cover the unpainted surfaces with a good quality
household floor paste wax.
The basic saw unit is shown as shipped here in Fig. 2.
ASSEMBLY

ASSEMBLY TOOLS REQUIRED

* Phillips head screw driver (not supplied)
* 12mm, 13mm and 18mm open end wrenches (not supplied)
* Other wrenches and a drill with a 1/4 inch bit may be required, depending on what fence or tables will be used

ASSEMBLY TIME ESTIMATE - 2 to 3 hours

Fig. 2
FOR YOUR OWN SAFETY, DONOT CONNECTTHE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTANDTHE ENTIRE
INSTRUCTION MANUAL.
THE SAW IS EXTREMELYHEAVY. HAVE TWO OR MORE PEOPLE HELP LIFT AND MOVE
MACHINE AROUND DURING ASSEMBLY.
1
29
12
11
13
19
20
Fig. 2

Fig. 2 Parts

1. 7/16"-20 x 11/4" Hex Head Screw (6)
2. 7/16" Flat Washer (6)
3. 7/16" Lock Washer (6)
4. M8x30 Hex Head Screw (1)
5. M8 Nut (1)
6. M8 lock washer (1)
7. M8 flat washer (1)
8. M8x25 Hex Head Screw (2)*
9. M8 Washer (2)*
10. M8 Lock Washer (2)*
11. 1/4”-20x3/8” Round Head Tap Screw (8)
12. M4 x 10mm Round Head Screw (6)
13. 1/4"-20 x 3/4" Hex Head Screw (2)
14. 1/4" Flat Washer (2)
15. 1/4" Lock Washer (2)
16. 5/16"-18 x 5/8Carriage Head Screw (1)
17. 5/16"hex nut (1)
18. 5/16" flat washer (1)
19. Nylon Washer (2)
20. M5x20mm Screw (1)
21. Washer for Miter Gage (1)
* Parts 8, 9 and 10 are included to attach the
rear rail of the fence to the table of this saw.
54
3
8
14
15

16 18

17
21
67
10