Craftsman 917.27075 TROUBLESHOOTING PROBLEM Poor cut - uneven contd, rMower blades will

Models: 917.27075

1 60
Download 60 pages 33.84 Kb
Page 30
Image 30
TROUBLESHOOTING

TROUBLESHOOTING

PROBLEM

Poor cut - uneven

!(cont'd)

rMower blades will

not rotate

Poor grass dis-

charge

Headlight(s) not working (if so equipped)

Battery will not charge

CHART

CAUSE

Clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels.

Obstruction in clutch mechanism.

Worn/damaged mower drive belt.

Frozen idler pulley.

Frozen blade mandrel.

Engine speed too slow.

Travel speed too fast.

Wet grass.

Mower deck not level.

Low/uneven tire air pres- sure.

Worn, bent or loose blade.

Buildup of grass, leaves and trash under mower.

Mower drive belt worn.

Blades improperly in- stalled.

Improper blades used.

Clogged mower deck vent holes from buildup of

grass, leaves, and trash around mandrels.

Switch is "OFF".

Bulb(s) burned out.

Faulty light switch.

Loose or damaged wiring.

Blown fuse.

Bad battery cell(s).

Poor cable connections.

Faulty regulator (if so equipped),

I • Faulty alternator.

CORRECTION

Clean around mandrels to open vent holes.

Remove obstruction.

Replace mower drive belt.

Replace idler pulley.

Replace blade mandrel.

Place throttle control in "FAST" position.

Shift to slower speed.

Allow grass to dry before mowing.

Level mower deck.

Check tires for proper air pressure.

Replace/sharpen blade. "tighten blade bolt.

Clean underside of mower housing.

Replace mower drive belt.

Reinstall blades sharp edge down.

Replace with blades listed in this manual.

Clean around mandrels to open vent holes.

Turn switch "ON".

Replace bulb(s).

Check/replace light switch.

Check wiring and connections,

Replace fuse.

Replace battery.

Check/clean all connections.

Replace regulator.

,• Replace alternator.

Engine "backfires"

• Engine

throttle control not

when turning en-

set at "SLOW"

gine =OFF"

position

for 30 seconds

 

before

stopping engine.

Move throttle control to

"SLOW" position and allow to idle for 30 seconds before

stopping engine.

30

Page 30
Image 30
Craftsman 917.27075 owner manual TROUBLESHOOTING PROBLEM Poor cut - uneven contd, rMower blades will, Remove obstruction