![](/images/new-backgrounds/1098206/9820637x1.webp)
TRACTOR
Always .observe safety rules when pedormmg any maintenance.
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance at high speed in
highestgear, then brake must be , adjusted. (See "TO ADJUST BRAKE" in
the Service and Adjustments section of this manual).
TIRES
•Maintain proper air pressure in all tires (See "PRODUCT SPECIFICATIONS" section of this manual).
•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may
cause tire damage.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also
prevents tire dry rot and corrosion.
OPERATOR PRESENCE SYSTEM
Be sure operator presence and interlock
systems are working properly. If your tractor does not function as descrifSed,
repair the problem immediately.
•The engine should not start unless the
clutch/brake pedal is fully depressed and attachement clutch control is in
the disengaged position.
•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.
•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine:
•The attachment clutch should never
operate unless the operator is in the seat.
BLADE CARE
For best results mower blades must be
kept sharp. Replace bent or damaged blades,
BLADE REMOVAL
•Raise mower to highest position to allow access to blades.
•Remove hex bolt, lock washer and flat washer secudng blade.
•Install new or resharpened blade with
trailing edge up towards deck as
shown.
IMPORTANT: To ensure proper assem- bly, center hole in blade must align with star on mandrel assembly.
•Reassemble hex bolt, lock washer and flat washer in exact order as shown.
•Tighten bolt securely
IMPORTANT: Blade bolt is Grade 8 heal
treated.
Mandrel Assembly
Trailing Edge Up_ _/
Blade Center p_
Flat Washer_..._
Lock Washe,_"__ar
*A Grade 8 heat treated bolt can be identified by six lines on the bolt head.
TO SHARPEN BLADE
NOTE: We do not recommend sharpen- ing blade - but if you do, be sure the blade is balanced.
Care should be taken to keep the blade balanced. An unbalanced blade will cause excessive vibration and eventual damage to mower and engine.
•The blade can be sharpened with a file or on a grinding wheel. Do not attempt to sharpen while on the mower.
•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions
supplied with balancer.)
NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.
•Slide blade on to an unthreaded
portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.
5/8" _n_BLa6e.
Center Hole _!
BATTERY
Your tractor has a battery charging
_/oStem which is sufficient for normal use. wever, periodic charging of the battery
with an automotive charger will extend its life.
•Keep battery and terminals clean.
Keep small vent holes open. Keep battery bolts tight.
19 Recharge at