TROUBLESHOOTING CHART
PROBLEM
Will not start
Hard to start
Engine will not turn over
Engine clicks but will not start
Loss of power
CAUSE
•Out of fuel.
•Engine not "CHOKED" properly.
•Engine flooded.
•Bad spark plug.
•Dirty air filter.
•Dirty fuel filter.
•Water in fuel.
•Loose or damaged wiring.
•Carburetor out of adjustment. Service Adjustments
•Engine valves out of adjustment.
•Dirty air filter.
•Bad spark plug.
•Weak or dead battery.
•Dirty fuel filter.
•Stale or dirty fuel.
•Loose or damaged wiring.
•Carburetor out of adjustment.
•Engine valves out of adjustment.
•Clutch/brake pedal not depressed
•Attachment clutch is engaged.
•Weak or dead battery.
•Blown fuse.
•Corroded battery terminals.
•Loose or damaged widng.
•Faulty ignition switch.
•Faulty solenoid or starter.
•Faulty operator presence switch(es).
•Weak or dead battery.
•Corroded battery terminals.
•Loose or damaged wiring.
•Faulty solenoid or starter.
•Cutting too much grass/too fast.
•Throttle in "CHOKE" position.
CORRECTION
•Fill fuel tank.
•See "TO START ENGINE" in Operation section.
•Wait several minutes before attempting to start,
•Replace spark plug.
•Clean/replace air filter.
•Replace fuel filter.
•Drain fuel tank and carbure tor, refill tank with fresh
gasoline and replace fuel filter.
•Check all wiring.
i, Seesection"To. Adjust Carburetor" in
•Contact an authorized service center/department.
•Clean/replace air filter.
•Replace spark plug.
•Recharge or replace battery.
•Replace fuel filter.
•Drain fuel tank and refill with fresh gasoline.
•Check all wiring.
•See "To Adjust Carburetor" in
Service Adjustments section.
•Contact an authorized service center/department.
•Depress clutch/brake pedal.
•Disengage attachment clutch.
•Recharge or replace battery.
•Replace fuse.
•Clean battery terminals.
•Check all widng.
•Check/replace ignition switch.
•Check/replace solenoid or starter.
•Contact an authorized service center/department.
•Recharge or replace battery.
•Clean battery terminals.
•Check all wiring.
•Check/replace solenoid or starter.
•Set in =Higher Cut" position/ reduce speed.
•Adjust throttle control,
30
