BATrERY
Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery
with an automotive charger will extend its life.
•Keep battery and terminals clean.
•Keep battery bolts tight.
•Keep small vent holes open.
•Recharge at
TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and terminals can cause the battery to "leak" power.
•Open battery box door.
•Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
•Rinse the battery with plain water and dry.
•Clean terminals and battery cable ends with wire brush until bright.
•Coat terminals with grease or petro- leum jelly.
•Reinstall battery (See =REPLACING
BATTERY" in the SERVICE AND
ADJUSTMENTS section of this
manual).
V-BELTS
Check
wear.
TRANSAXLE COOLING
Keep transaxle free from
ENGINE
LUBRICATION
Only use high quality detergent oil rated with API service classification SF, SG, or
SH. Select the oil's SAE viscosity grade according to your expected operating
temperature.
SAE VISCOSITY GRADES
"C .30- | .10- | to" | _0= |
TEMPERAI_JRE RANGE ANTICIPATE D BEFORE NEx'r OIL CHANGE
Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one year.
Check the crankcase oil level before starting the engine and after each eight
(8) hours of operation. Tighten oil fill cap/
dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected before oil change. All oil must meet API service classification SF, SG or SH.
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
•Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.
•Remove drain plug.
•After oil has drained completely, replace oil drain plug and tighten securely.
•Refill engine with oil through oil fill dipstick tube. Pour slowly. Do not overfill. For approximate capacity see
"PRODUCT SPECIFICATIONS" section of this manual.
•Use gauge on oil fill cap/dipstick for checking level, Insert dipstick into the tube and rest the oil fill cap on the tube. Do not thread the cap onto the
tube when taking reading. Keep oil at "FULL" line on dipstick. Tighten cap onto the tube securely when finished.
|
| Cover Knob | |
Air Cleaner |
| Wing Nut | |
Cover |
| ||
| Rubber | ||
Foam |
| ||
TGrommet | |||
Pre- | |||
\ | !_ _x_A'lr Cleaner | ||
| |||
Cleaner _ |
| _"_Paper Cartridge | |
Screen |
| _Base | |
|
| Oil Fil Cap/ | |
|
| _Air Cleaner | |
|
| Dipstick |
_.Oil Drain
Plug
CLEAN AIR SCREEN
Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers.
18