REPLACING BATTERY
4_LWARNING: Do not short b,attery terminals oy allowing a wrencn or any
other object to contact both terminals at
the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift seat pan to raised position.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in
same position as old battery.
4.First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal
5.Connect BLACK grounding cable to negative
Seat Pan
Terminal | Keps |
Cover | Hex |
| |
| Bolt |
Positive, |
|
(Red) |
|
Cable | Negative (Black) Cable |
|
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to reconnect headlight wire connector.
\ \
\
Headlight Wire
Connector
ENGINE
Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any
be performed by an authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position.
25