Craftsman 917.271641 owner manual Replacing Battery

TO ATTACH JUMPER CABLES -

1.Connect each end of the RED cable to {he POSITIVE (+) terminal of each battery, taking care not to short against chassis•

2.Connect one end of the BLACK cable

to the NEGATIVE (-) terminal of fully charged battery.

3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

1.BLACK cable first from chassis and then from the fully charged battery.

2.RED cable last from both batteries.

Positive Terminal Negative Terminal

Positive Terminal Negative Terminal

REPLACING BATTERY

_CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding•

1.Lift seat pan to raised position and open battery box door.

2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

3.Install new battery with terminals in same position as old battery.

4.First connect RED battery cable to positive (+) terminal with hex bolt and

keps nut as shown. Tighten securely.

5.Connect BLACK grounding cable to negative (-)terminal with remaining

hex bolt and keps nut. Tighten securely•

6.Close battery box door.

Seat PanI

Bakery

Door_ i! _,_

Box [_

Positive (Red) Cable

Cable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Pull bulb holder out of the hole in the backside of the grill.

3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorty, stop running, or prevent it from starting.

•Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-typeplug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL AS- SEMBLY

1, Raise hood.

2.Unsnap headlight wire connector,

3.Stand in front of tractor, Grasp hood at sides, tilt toward engine and lift off of tractor.

4.To repla(_e, reverse above procedure.

	_,L L		Hood
i
I
i
i	_	"/	HeadlightWire
•	/ o_	,	Connector

26