G e t t i n g s t a r t e d
6.Note: Do not remove the MMC card in the middle of an operation when the card is being accessed. Removing the card in the middle of an operation may damage the memory card as well as the device, and data stored on the card may be corrupted.
You can remove a memory card after you have removed the back cover even when the battery is inserted.
Charging the battery
1.Connect the charger to an AC wall outlet.
2.Connect the power cord to the bottom of the device. See Fig Keys and connectors{No generated text before found for '#comma'} p.11. The battery indicator bar starts scrolling. If the battery is totally discharged, it may take a few minutes before the charging indicator is shown. The device can be used while charging.
3.When the battery is fully charged, the bar stops scrolling. Disconnect the charger from the device and then from the AC outlet.
Switching the device on and off
To switch the device on, press and hold the power key. The communicator can be used without the phone functions when a SIM card is not inserted or when the Offline profile is selected.
If the device asks for a PIN or security code, enter the code, and press OK. To switch the device off, press and hold the power key.
Your device has a separate GSM radio and wireless LAN radio. Switching off the device by pressing the power key on the device cover switches off both radios. Note, however, that switching off the device or using the offline profile does not prevent you from establishing a new wireless LAN connection. Therefore, remember to comply with any applicable safety requirements when establishing and using a wireless LAN connection.See "Setting the offline profile{No generated text before found for '#comma'}" p.22.
Tip: When you switch the phone on, it may recognize the SIM card provider and configure the correct text message, multimedia message, and GPRS settings automatically. If not, contact your service provider for the correct settings.
Tip: If you have removed the battery and inserted it back rapidly, you may need to press the power key before the device starts up.
The communicator interface starts up first after the battery is inserted. You cannot switch on the cover phone immediately after the battery has been inserted, you must wait until the communicator interface has started.
Your device has two internal antennas.
Note: As with any other radio transmitting device, do not touch either of the antennas unnecessarily when the device is switched on. Contact with the antenna affects call quality and may cause the device to operate at a higher power level than otherwise needed. Not touching the antenna area during a phone call optimises the antenna performance and the talktime of your device.
Normal position: See the diagram below for normal use of the device at the ear for voice calls. See "Operating environment{No generated text before found for '#comma'}" p.101.
Copyright © 2004 Nokia. All Rights Reserved. | 9 |
