Mandrel Idler Pulleys
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable brake system which is mounted on the side of the transaxle.
If tractor requires more than six (6) feet stopping distance at high speed in highest gear on a level dry concrete or paved surface, then brake must be adjusted.
1.Depress clutch/brake pedal and engage parking brake.
2.Measure distance between brake operating arm and nut "A" on brake rod.
3.If distance is other than
3.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades.
4.Pull belt toward front of tractor and remove downward from around engine pulley.
5.Install new belt by reversing above procedure.
EnginePulley _
o, e,o,sr,ng
ii:i n2sl i1:1/_
Input Pulley
becomes
4.Road test tractor for proper stopping distance as stated above. Readjust if necessary. If stopping distance is still greater than six (6) feet in highest gear, further maintenance is necessary.
Contact a Sears or other qualified service center.
WIth Parking Brake
"Engaged"
Jam N,ut
UA"
r_
_peratingArm
Do not touch this nut. If further brake adjustment is
necessarycontactyournearestauthorizedservice center/department
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage parking brake. For assistance, there is a
belt installation guide decal on bottom side of left footrest.
t.Remove mower (See "TO REMOVE
MOWER" in this section of this
manual.)
2. Remove belt from stationary idler and clutching idler.
25
TRANSAXLE MOTION CONTROL LEVER NEUTRAL ADJUSTMENT
The motion control lever has been preset at the factory and adjustment should not be necessary.
1.Loosen adjustment bolt in front of the right rear wheel, and lightly tighten.
2.Start engine and move motion control lever until tractor does not move forward or backward.
3.Hold motion control lever in that position and turn engine off.
4.While holding motion control lever in place, loosen the adjustment bolt.
5.Move motion control lever to the neutral (N) (lock gate) position.
6.Tighten adjustment bolt securely. NOTE: If additional clearance is needed
to get to adjustment bolt, move mower deck height to the lowest position. After above adjustment is made, if the tractor still creeps forward or backward while motion control lever is in neutral position, follow these steps:
t.Loosen the adjustment bolt.
2.Move the motion control lever 1/4 to
1/2 inch in the direction it is trying to creep.
3.Tighten adjustment bolt securely.
4.Start engine and test.
5.If tractor still creeps, repeat above steps until satisfied.
