REPLACINGBATTERY
TO REMOVE HOOD AND GRILL AS- SEMBLY
_IkCAUT!ON: Do not short battery terminais Dy allowing a wrench or any
other object to contact both terminals at the same time, Before connecting battery, remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first
to prevent sparking from accidental grounding.
1.Lift seat pan to raised position and open battery box door.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in
same position as old battery.
4, First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.
5.Connect BLACK grounding cable to negative
6.Close battery box door.
Seat PanI
Battery
Ooor_ F_II_
Box__
Keps
Hex Belt
Positive(Red) Cable Negative (Black) Cable
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in
the backside of the grill. 4, Close hood,
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check widng. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
1, Raise hood.
2, Unsnap headlight wire connecter.
3, Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4. To replace, reverse above procedure.
,, _ Hood
i_ Headlight Wire
._) Connector
ENGINE
Maintenance, repair,or replacement of the emission control devicas and systems, which
are being done at the customers expense,
may be performed by any
repairs must be performed by an authorized engine manufacture¢s service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttlecontrol has been preset at the factory and adjustment should not be necessary.Check adjustment as described
below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke position. Slowlymove lever from choke to fast position.
2.Check to see if hole in throttlelever and hole in speed control bracket are aligned.
3.If holes are not aligned, loosen cable clamp screw and align the holes by
insertinga pencil or a 1/4" drillbit through beth holes.
4, Pull throttlecable up to remove slack and tightencable clamp screw, Remove alignment pencil or drillbit.
Cable _
Clamp _.__.__L:_['_
Screw
Speed Coontrol _'_/_ I
_Bracket
27