| Keps Nut _ |
| u..., | TO REMOVE HOOD AND GRILL | ||
Terminal | ..... | _ _- | _ | .. ''°^ | ASSEMBLY | |
A=e |
|
| .... | Bolt | • | Raise hood. |
|
|
| ||||
|
|
| • | Unsnap headlight wire connector. | ||
|
|
| Stand in front of tractor. Grasp hood at | |||
|
|
|
|
|
| sides, tilttoward engine and liftoff of |
.- | _ |
|
| (Red) Cable |
| tractor. |
Negative(Black) | • | To replace, reverse above procedure. | ||||
Guard/ | Cable |
|
| |||
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the gdll.
•Replace bulb inholder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.
•Check wiring. See electrical wiring dia- gram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO ADJUST ATTACHMENT LIFT SPRING
•While holding spring bushing with wrench, loosen jam nut.
•Turn adjustment bolt clockwise to
extend spring and reduce lift effort for heavier attachments.
•Tum adjustment bolt counterclockwise for lighter attachments.
•Retighten jam nut against spdng bush- ing.
IMPORTANT: Do not adjust for maximum spdng tension when using light attach- ments such as a mower. Adjust lift lever springto aid in liftingattachment. Do not overpower spring. When removing attach- ment, always adjust spring]ension to its lowest position.
AdjU__Bushing
_Attachment
_LiftSpdng
!(//" - / JamNut
Headlight
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non- road engine repair establishment or indi- vidual. Warranty repairs must be per-
formed by an authorized engine manufac- turer'sservice outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
controlWith enginelever notto fastrunning,positionmove. throttle
Check that speed control lever is
against stop screw. If it is not, loosen casing clamp screw and pull throttle
cable untillever is against screw. Tighten clamp screw securely.
Idle Fuel Adjusting
Idle Speed
I Screw
Throttle.
Cable
Choke
, Control
StopCable
Screw
Clamp Screw
29
