NOTE:Theoriginal equipmentbatteryon your tractor is maintenancefree. Do not attemptto openor removecaps or covers.

Adding or checkinglevelof electrolyteis notnecessary.

TO CLEANBATTERYAND TERMINALS

Corrosionand dirt on the battery and terminalscan cause the batteryto "leak" power.

1.DisconnectBLACKbatterycablefirst then RED batterycableand remove batteryfrom tractor.

2.Rinsethe batterywith plainwater and dry.

3.Cleanterminalsand batterycable ends with wire brush until bright.

4.Coatterminalswith greaseor petro- leumjelly.

5.Reinstallbattery(See "REPLACING BATTERY"in the SERVICEAND AD- JUSTMENTSsectionof this manual).

TRANS._LE COOLING

Keeptransaxlefree from build-upof dirt and chaff whichcan restrictcooling.

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SG-SL.

Select the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

F

30

32 40

60

80

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

Change the oil after every 50 hours of op- eration or at least once a year if the tractor is not used for 50 hours in one year.

Check the crankcase oil level before start- ing the engine and after each eight (8) hours of operation.

TO CHANGE ENGINE OIL

Determine temperature range expected

before oil change. All oil must meet API service classification SF-SJ.

Be sure tractor is on level surface.

Oil will drain more freely when warm.

Catch oil in a suitable container.

1.Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

2.Remove yellow cap from end of drain valve and install the drain tube onto the

fitting.

oil Drain Valve

Closed and Locked Position

Yellow Cap

Drain Tube

3.Unlock drain valve by pushing inward slightly and turning counterclockwise.

4.To open, pull out on the drain valve.

5.After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.

6.Remove the drain tube and replace the cap onto the end of the drain valve.

7.Refill engine with oil through oil fill dip- stick tube. Pour slowly. Do not overfill.

For approximate capacity see "PROD-

UCT SPECIFICATIONS" section of this manual.

8.Use gauge on oil fill cap/dipstick for checking level. Insert dipstick into the tube and rest the oil fill cap on the tube. Do not thread the cap onto the tube when taking reading. Keep oil at "FULL:' line on dipstick. Tighten cap onto the tube securely when finished.

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

19

Page 19
Image 19
Craftsman 917.27317 owner manual Belts, Lubrication, To Change Engine OIL, Engine OIL Filter