2.Connectone end of the BLACKcable
to the
3.Connectthe other end of the BLACK
cable(D) to goodchassisground, awayfrom fuel tank and battery.
TO REMOVECABLES,REVERSE ORDER-
1.BLACKcablefirst from chassis and then from the fully charged battery.
2.RED cablelast from both batteries.
| 02614 |
Weak or Dead | Fully Charged |
Battery | Battery |
REPLACmNG BATTERY
_kWARNmNG: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift seat pan to raised position.
2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.
3.Install new battery with terminals in same position as old battery.
4.First connect RED battery cable to positive (+) terminal with hex bolt and
keps nut as shown. Tighten securely. Slide terminal cover over terminal
5.Connect BLACK grounding cable to negative
Label
Terminal |
|
Cover | Keps |
| Nut |
Hex | |
| Bolt |
Positive (Red)
CaMeNegative (Black) Cable
TO REPLACE HEADUGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
mNTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
,, Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRmLL AS-
SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Hood
Headlight Wire
Connector
25
