,_CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1, Depress clutch/brake pedal fully and set parking brake.
2.Place gearshift lever in neutral (N) position.
3.Place attachment clutch in =DISENGAGED" position.
4.Turn ignition key "OFF" and remove key.
5, Make sure the b_ades and all moving parts have completely stopped.
6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug,
TRACTOR
TO REMOVE MOWER
1.Place attachment clutch in "DISEN-
GAGED" position.
2.Turn height adjustment knob to lowest setting.
3, Lower mower to its lowest position.
4.Remove retainer spring holding anti- swaybar to chassis bracket and disengage
5.Remove four retainer springs from front plate assembly and remove plate.
6.Remove retainer springs from suspension arms at deck and disen- gage arms from deck.
7, Raise attachment lift to its highest
position.
8.Slide mower forward and remove belt from electric clutch pulley.
9.SLide mower out from under right side of tractor,
TO INSTALL MOWER
Follow procedure described in "tNSTALL
MOWER AND DRIVE BELT" in the
Assembly section of this manual.
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD-
UCT SPECIFICATIONS" section of this manual). If tires are over or undednflated, you wilt not properly adjust your mower.
•Raise mower to its highest position,
•Measure height from bottom edge of mower to ground level at front corners of mower. Distance =A" on both sides of mower should be the same.
•If adjustment is necessary, make adjustment on one sLdeof mower only.
•To raise one side of mower, tighten lift link adjustment nut on that side.
•To lower one side of mower, loosen lift link adjustment nut on that side.
Suspension |
| Eiectdc |
| FrontMower | ClutchPulley |
|
| |
Chassis | Bracket | Front |
| ||
|
| Plate |
Retainer |
|
|
|
| Springs |
|
| (Both Sides) |
|
| |
Bar |
| Bracket |
|
| |
Retainer | Springs |
|
22
