INSTALL MOWER AND DRIVE BELT
Be sure tractor is on level surface and
mower suspension arms are raised with attachment lift control. Engage parking brake.
1.Cut and remove ties securing anti-
sway bar and belts. Swing
2.Slide mower under tractor with
deflector shield to right side of tractor. IMPORTANT; Check belt for proper routing in all mower pulley grooves.
3.If equipped, turn height adjustment knob counterclockwise until it stops.
4.Lower mower linkage with attachment lift control.
5.Install belt into electric clutch pulley groove.
6.Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown.
7.Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.
8.Position front plate assembly between front mower brackets. Raise deck and plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate and mower brackets.
NOTE; To assist in locating hole in
flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower
9.Connect
10.If equipped, turn height adjustment knob clockwise to remove slack from
mower suspension.
11.Raise deck to highest position. 12.Assemble gauge wheels as shown
using long shoulder bolts, 3/8 washers, and
13.Adjust gauge wheels before operat- ing mower as shown in the Operation section of this manual.
CHECK TIRE PRESSURE
The tires on your tractor were overin- flated at the factory for shipping pur- poses. Correct tire pressure is important for best cutting performance.
•Reduce tire pressure to PSI shown in
"PRODUCT SPECIFICATIONS" section of this manual.
|
| Chassis |
| Front | Electric | |
|
| Bracket |
| Suspension | Clutch | |
| Double Loop |
| Suspension Front | Pulley | ||
| Retainer |
| Arms | Mower Brackets |
| |
|
| Bracket |
| |||
|
|
|
|
|
| Front Plate |
Sho_der |
|
|
|
|
| |
Bolt | Wheel |
|
|
|
| |
|
|
|
|
|
| Single |
3/8 |
|
|
|
|
| Loop |
Washer |
|
|
|
| Retainer | |
|
|
|
| Springs | ||
| Double |
|
|
| ||
|
|
|
|
| ||
| Center | Loop |
|
|
|
|
| Locknut | Retainer |
|
|
|
|
|
| Spring | Bar |
|
| Deflector |
I
Use PliersFor I DoubleLoop
(Outwardpointing
RetainerSprings I RetainerSpring deck pins)
LoopUp
10