Hex
Bolt
Guard
Cabte
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged v_dng may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO ADJUST
1.White holding spring bushing with wrench, loosen jam nut.
•Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments.
•Turn adjustment bolt counterclockwise for lighter attachments.
2.Retighten jam nut against spring bushing.
IMPORTANT: Do not adjust for maximum spring tension when using tight attach- ments such as a mower. Adjust lift lever spring to aid in lifting attachment. Do not overpower spring. When removing attachment, always adjust spring tension to its lowest position.
Bushing
N_ _A_achment Uff
Spnng
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1, Raise hood.
2, Unsnap headlight wire connector.
3, Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.To replace, reverse above procedure.
Headlight Wire
ENGINE
Maintenance, repair, or replecement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any
TO ADJUST THRO'n'LECONTROL
CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw.
Tighten clamp screw securely.
IdleFuelAdjusting Idle speedAdjusting Needle
Thro_le
Control
Cable
:hoke Control Cable
27ScreV_lamp
