Cisco Systems 1710 8 , 9 , 10

8 Verify Your Installation

After the router is powered on, the following LEDs confirm that you have correctly installed your router.

9 For More Information

For more information about installing or configuring your Cisco 1710 Security router, see the following documents available

on Cisco.com:

•Cisco 1710 Security Router Hardware Installation Guide

•Cisco 1710 Security Router Software Configuration Guide

•Cisco Security Device Manager Troubleshooting Guide

•The Cisco Warranty card, included in the accessory kit, which lists telephone numbers, e-mail addresses, and World Wide

Web URLs for getting information directly from Cisco Systems

For more information about SDM, visit http://www.cisco.com/go/sdm

10 Obtaining Documentation

Cisco documentation and additional literature are available on Cisco.com. Cisco also provides several ways to obtain technical

assistance and other technical resources. These sections explain how to obtain technical information from Cisco Systems.

You can access the most current Cisco documentation at this URL:

http://www.cisco.com/univercd/home/home.htm

You can access the Cisco website at this URL:

http://www.cisco.com

PWR Front On when power is being supplied to the router.

OK Front On when the router software is loaded and

functional.

Blinking when the router is running a power-on

self-test (POST). Continual blinking can indicate a

problem with the router, although the LED will

also blink if the router is in ROMMON mode.

Refer to the “Troubleshooting” chapter in the

hardware installation guide for more information.

LNK (One for each Ethernet

port)

Back On when the router is correctly connected to the

Ethernet network through the 10BT and 10/100

ETHERNET ports.

FDX (One for each Ethernet

port)

Back On when the associated Ethernet port is operating

in full-duplex mode. The 10BT port does not

perform autosensing for full-/half-duplex mode;

the default setting is for half-duplex operation.

100 (10/100 ETHERNET port

only)

Back On when the 10/100 ETHERNET port is

operating at 100 Mbps.

10BT ACT and 10/100 ACT Front Blinking when there is network traffic on the

Ethernet connections.