Adjustment Sleeves
Jam Nuts
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL -
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal.
3.Repair tire and reassemble.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
REAR WHEEL -
1.Block rear axle securely.
2.Remove five (5) hub bolts to allow wheel removal.
3.Repair tire and reassemble. Replace and tighten hub bolts securely.
Washers
Retaining
Ring
Axle
Cover
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry rot and corrosion.
TO START ENGINE WITH AWEAK BATTERY
_CAUTION:
batteries. Always wear eye protection when around batteries.
If your battery is too weak to start the
engine, it should be recharged. (See "BATTERY" in the MAINTENANCE
section of this manual).
If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: Your tractor is equipped with a 12 volt negative grounded system. The other vehical must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1.Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.
2.Connect one end of the BLACK cable to the NEGATIVE
3.Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER-
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
(+)_"P°sitive"_(-)=Negative"
REPLACING BATTERY
_CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
7.Connect BLACK grounding cable to negative
Tighten securely
. Close terminal access doors.
9.Close hood.
26
