_CTOR
Always observe safety rules when
performing any maintenance.
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance at high speed in
highest gear, then brake must be ad- justed. (See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual).
TIRES
•Maintain proper air pressure in all tires (See "PRODUCT SPECIFICATIONS" section of this manual).
•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may
cause tire damage.
NOTE: To seal tire punctures and prevent fiat tires due to slow leaks, tire sealant may be purchased from your local parts
dealer. Tire sealant also prevents tire dry rot and corrosion.
OPERATOR PRESENCE SYSTEM
Be sure operator presence and interlock systems are working properly. If your tractor does not function as described, repair the problem immediately.
•The engine should not start unless the brake pedal is fully depressed and attachement clutch control is in the disengaged position.
•When the engine is running, any attempt by the operator to leave the
seat without first setting the parking brake should shut off the engine.
•When the engine is running and the
attachment clutch is engaged, any attempt by the operator to leave the
seat should shut off the engine.
•The attachment clutch should never
operate unless the operator is in the seat.
BLADE CARE
For best results mower blades must be
kept sharp. Replace bent or damaged blades.
BLADE REMOVAL
1.Raise mower to highest position to allow access to blades.
2.Remove hex bolt, lock washer and fiat washer securing blade.
3.Install new or resharpened blade with
trailing edge up towards deck as shown.
IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.
4.Reassemble hex bolt, lock washer and fiat washer in exact order as shown.
5.Tighten bolt securely
IMPORTANT: | Blade bolt is grade 8 heat | |
treated. |
|
|
Trailin | Blade | |
Lock |
|
|
| _Hex | Bolt (Grade)' |
*A Grade 8 heat treated bolt can be identified by six lines on the bolt head.
TO SHARPEN BLADE
NOTE: We do not recommend sharpen-
ing blade - but if you do, be sure the blade is balanced.
Care should be taken to keep the blade balanced. An unbalanced blade will cause excessive vibration and eventual damage to mower and engine.
•The blade can be sharpened with a file or.on a grinding wheel. Do not attempt to sharpen while on the mower.
•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone bal- ancer, follow the instructions supplied with balancer.)
NOTE: Do not use a nail for balancing blade. The lobes of the center hole may appear to be centered, but are not.
•Slide blade on to an unthreaded
portion of the steel bolt or pin and hold
the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen
the heavy end until the blade is balanced.
5/8" Bolt | de |
Center Hole
BATTERY
Your tractor has a battery charging system which is sufficient for normal use. How-
ever, periodic charging of the battery with an automotive charger will extend its life.
19
