Terminal | Hex |
Access | Bolt |
| (Red) |
| Cable |
Guard | _gative (Black) |
| Cable |
TO REPLACE | HEADLIGHT BULB |
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poody, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO ADJUST ATTACHMENT LIFT SPRING
1.While holding spring bushing with wrench, loosen jam nut.
•Turn adjustment bolt clockwise to extend spring and reduce lift effort for heavier attachments.
•Turn adjustment bolt counterclockwise for lighter attachments.
2.Retighten jam nut against spring bushing.
IMPORTANT: Do not adjust for maximum spring tension when using light attach- ments such as a mower. Adjust lift lever spring to aid in lifting attachment. Do not overpower spring. When removing attachment, always adjust spring tension to its lowest position.
/_
_Bushing
W_I/ | /" | J_'mNut | "AttachmentLift | |
i | / _ | .... | o | Spring |
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4.To replace, reverse above procedure.
Headlight Wire
lector
ENGINE
Maintenance, repair, or replacement of the emission control devices and sys- tems, which are being done at the customers expense, may be performed by any
be performed by an authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.
Idle Fuel Adjusting | Idle speed Adjusting |
Needle |
|
Throttle
Control
Cable
Choke
Control
Cable
