Craftsman 917.2754 owner manual To SET Parking Brake, To Move Forward and Backward, Stopping

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

1.Depress clutch/brake pedal all the way down and hold.

2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake position.

Make sure parking brake will hold trac-

tor	secure.
	Attachment	Clutch	Lever
	"Engaged"	Position
Throttle/Choke		nition	Key
Control		"Disengaged"
		Position
"Brake"	Motion Control

•Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will

cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine run- ning, hot engine exhaust gases may cause "browning" of grass. To eliminate this pos- sibility, always stop engine when stopping tractor on grass areas.

_ICAUTION: Always stop tractor com- pletely, as described above, before leaving the operator's position.

TO USE THROTTLE CONTROL Always operate engine at full throttle.

•Operating engine at less than full throttle reduces the battery charging rate.

•Full throttle offers the best bagging and mower performance.

TO MOVE FORWARD AND BACKWARD

Clutch/Brake

Parking Brake

The direction and speed of movement is controlled by the motion control lever.

1. Start tractor with motion control lever in

Pedal"Disengaged" "Engaged"

Position Position

STOPPING

MOWER BLADES -

•To stop mower blades, move attachment

clutch lever to "DISENGAGED" position.

GROUND DRIVE -

•To stop ground drive, depress clutch/ brake pedal all the way down.

•Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is depressed.

ENGINE -

•Move throttle control between half and

full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) posi-

tion, before stopping, may cause engine to "backfire".

•Turn ignition key to "STOP" position and remove key. Always remove key when

leaving tractor to prevent unauthorized

use.

	neutral	(N) position.
2.	Release	parking brake.
3.	Slowly move motion control lever to
	desired	position.

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are mea- sured from the ground to the blade tip with the engine not running. These heights

are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to ap- proximately 2-1/2 inches during the cool season and to over 3 inches during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over

6 inches in height should be mowed twice. Make the first cut relatively high;

13the second to desired height.