TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level surface.
1.Adjust mower to desired cutting height (See "TO ADJUST MOWER CUTTING HEIGHT" in this section of manual).
2.With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in ap- propriate hole with shoulder bolt, 3/8 washer, and
3.Repeat for opposite side, installing gauge wheel in same adjustment hole.
Attachment | Attachemnt |
Clutch Lever |
|
"Engaged" | High |
Position | Position |
/
Position
"Disengaged '_
PositionDeflector
OPERATING IN REVERSE
Your tractor is equipped with a Reverse Operation System (ROS). Any attempt by the operator to travel in the reverse direc- tion with the attachment clutch engaged will shut off the engine unless the ignition key is placed in the ROS "ON" position.
Gauge
Wheel
Mountinc
Gauge Wheel
Bolt
_,WARNING: Backing up with the at- tachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in
reverse unless absolutely necessary.
USING THE REVERSE OPERATION SYSTEM -
1. Move motion control lever to neutral |
(N) position. |
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitating or cutting off when operating your equip- ment on rough, rolling terrain or hills.
1.Select desired height of cut.
2.Start mower blades by engaging at- tachment clutch control.
TO STOP MOWER BLADES - disengage attachment clutch control.
,_CAUTION: Do not operate the mower without either the entire grass catcher,
on mowers so equipped, or the deflector shield in place.
2. | With | engine | running, |
| turn | ignition | key | ||||
| counterclockwise | to | ROS | "ON" | posi- | ||||||
| tion. |
|
|
|
|
|
|
|
|
|
|
3. | Look | down |
| and | behind | before | backing | ||||
| up. |
|
|
|
|
|
|
|
|
|
|
4. | Slowly | move | motion | control | lever | to | |||||
| reverse (R) position to start movement. | ||||||||||
5. | When | use | of the ROS | is no | longer |
| |||||
| needed, turn the ignition key clockwise | ||||||||||
| to engine | "ON" | position. |
|
|
|
|
ROS "ON" Position Engine "ON" Position (Normal Operating)
14