WARNING:SERVICE ORTOADJUSTMENTS:AVOIDSERIOUS INJURY, BEFORE PERFORMING ANY
1.Depress clutch/brake pedal fully and set parking brake.
2.Place motion control lever in neutral (N) position.
3.Place attachment clutch in "DISENGAGED" position.
4.Turn ignition key to "STOP" and remove key.
5.Make sure the blades and all moving parts have completely stopped.
6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
1.Place attachment clutch in "DISEN- GAGED" position.
2.Move attachment lift lever forward to lower mower to its lowest position.
3.Roll belt off engine pulley.
4.Remove small retainer spring, and remove clutch spring off pulley bolt.
5.Remove large retainer spring, slide
collar off and push housing guide out of bracket.
6.Disconnect
7.Disconnect suspension arms from rear deck brackets by removing retainer springs.
8.Disconnect front links from deck by removing retainer springs.
9.Raise lift lever to raise suspension
arms. Slide mower out from under trac- tor.
Small Retainer Spring
Clutch Spring
Small Retainer
Clutch Spring
S
Retainer
Spring
Bar
Housing
Guide
Retainer Spring
IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook the clutch spring Into square hole in frame.
TO INSTALL MOWER
1.Raise attachment lift lever to its highest position.
2.Slide mower under tractor with deflec- tor shield to right side of tractor.
3.Lower lift lever to its lowest position.
4.Connect front links to mower deck and secure with retainer springs.
5.Connect suspension arms to rear deck brackets and secure with retainer springs.
6.Connect
bracket and secure with retainer spring.
7.Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring.
8.Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.
9.Install belt onto engine pulley.
Engine
Pulley
Front Link
Retainer Springs
(Both Sides)
Deflector
23
