Craftsman 917.27582 Troubleshooting Chart, Problem, Cause, Correction, Will not start, turn over

Models: 917.27582

1 34
Download 34 pages 17.52 Kb
Page 30
Image 30

TROUBLESHOOTING CHART:

See appropriate section in manual unless directed to Sears service center

PROBLEM

CAUSE

CORRECTION

Will not start

1.

Out of fuel.

1.

Fill fuel tank.

 

2.

Engine not “CHOKED”

2.

See “TO START ENGINE” in

 

 

properly.

 

Operation section.

 

3.

Engine fl ooded.

3.

Wait several minutes before

 

 

 

 

attempting to start.

 

4.

Bad spark plug.

4.

Replace spark plug.

 

5.

Dirty air fi lter.

5.

Clean/replace air fi lter.

 

6.

Dirty fuel filter.

6.

Replace fuel fi lter.

 

7.

Water in fuel.

7.

Empty fuel tank and carbure-

 

 

 

 

tor, refi ll tank with fresh gas-

 

 

 

 

oline and replace fuel fi lter.

 

8.

Loose or damaged wiring.

8.

Check all wiring.

 

9.

Carburetor out of adjustment.

9.

See “To Adjust Carburetor”

 

 

 

 

in Service and Adjustments

 

 

 

 

section.

 

10. Engine valves out of

10. Contact a Sears or other

 

 

adjustment.

 

qualifi ed service center.

 

 

 

 

 

Hard to start

1.

Dirty air fi lter.

1.

Clean/replace air fi lter.

 

2.

Bad spark plug.

2.

Replace spark plug.

 

3.

Weak or dead battery.

3.

Recharge or replace battery.

 

4.

Dirty fuel filter.

4.

Replace fuel fi lter.

 

5.

Stale or dirty fuel.

5.

Empty fuel tank and refill tank

 

 

 

 

with fresh, clean gasoline.

 

6.

Loose or damaged wiring.

6.

Check all wiring.

 

7.

Carburetor out of adjustment.

7.

See “To Adjust Carburetor” in

 

 

 

 

Service and Adjustments

 

 

 

 

section.

 

8.

Engine valves out of

8.

Contact a Sears or other

 

 

adjustment.

 

qualifi ed service center.

 

 

 

 

 

Engine will not

1.

Brake pedal not depressed.

1.

Depress brake pedal.

turn over

2.

Attachment clutch is engaged.

2.

Disengage attachment clutch.

 

3.

Weak or dead battery.

3.

Recharge or replace battery.

 

4.

Blown fuse.

4.

Replace fuse.

 

5.

Corroded battery terminals.

5.

Clean battery terminals.

 

6.

Loose or damaged wiring.

6.

Check all wiring.

 

7.

Faulty ignition switch.

7.

Check/replace ignition switch.

 

8.

Faulty solenoid or starter.

8.

Check/replace solenoid or

 

 

 

 

starter.

 

9.

Faulty operator presence

9.

Contact a Sears or other

 

 

switch(es).

 

qualifi ed service center.

 

 

 

 

 

Engine clicks but

1.

Weak or dead battery.

1.

Recharge or replace battery.

will not start

2.

Corroded battery terminals.

2.

Clean battery terminals.

 

3.

Loose or damaged wiring.

3.

Check all wiring.

 

4.

Faulty solenoid or starter.

4.

Check/replace solenoid or

 

 

 

 

starter.

 

 

 

 

 

Loss of power

1.

Cutting too much grass/too

1.

Raise cutting height/reduce

 

 

fast.

 

speed.

 

2.

Throttle in “CHOKE” position.

2.

Adjust throttle control.

 

3.

Build-up of grass, leaves and

3.

Clean underside of mower

 

 

trash under mower.

 

housing.

 

4.

Dirty air fi lter.

4.

Clean/replace air fi lter.

 

5.

Low oil level/dirty oil.

5.

Check oil level/change oil.

 

 

 

 

 

30

Page 30
Image 30
Craftsman 917.27582 Troubleshooting Chart, Problem, Cause, Correction, Will not start, Hard to start, Engine will not