Chapter 3: Troubleshooting
Chapter 3
Troubleshooting
3-1 Troubleshooting Procedures
Use the following procedures to troubleshoot your system. If you have followed all of the procedures below and still need assistance, refer to the ‘Technical Support Procedures’ and/or ‘Returning Merchandise for Service’ section(s) in this chapter. Always disconnect the AC power cord before adding, changing or installing any hardware components.
Before Power On
1.Make sure that the main ATX power connector at J1B1 and the
2.Make sure that no short circuits exist between the serverboard and chassis.
3.Disconnect all ribbon/wire cables from the serverboard, including those for the keyboard and mouse.
4.Remove all
5.Install CPUs and heatsinks (making sure they are fully seated) and connect the internal (chassis) speaker and the power LED to the serverboard. Check all jumper settings as well.
6.Use the correct type of onboard CMOS battery as recommended by the manufac- turer. To avoid possible explosion, do not install the CMOS battery upside down.
No Power
1.Make sure that no short circuits exist between the serverboard and the chas- sis.
2.Verify that all jumpers are set to their default positions.
3.Check that the 115V/230V switch on the power supply is properly set.
4.Turn the power switch on and off to test the system.
5.The battery on your serverboard may be old. Check to verify that it still supplies ~3VDC. If it does not, replace it with a new one.
No Video
1.If the power is on but you have no video, remove all the
2.Use the speaker to determine if any beep codes exist. Refer to Appendix A for details on beep codes.
