Craftsman 917.2759 manual _

9.Position front plate assembly between front mower brackets. Raise deck and

plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate

assembly and mower brackets.

NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower

side-to-side to give space between plate and mower brackets.

IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.

10.Engage belt tension rod by pushing rod into locking bracket.

_CAUTION: Belt tension rod is spring

loaded. Have a tight grip on rod and en- gage slowly.

11.Connect anti-sway bar to chassis bracket under left footrest and retain

with double loop retainer spring.

12.If equipped, turn height adjustment knob clockwise to remove slack from

mower suspension.

13.Raise deck to highest position.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure

tires are properly inflated (See "PROD-

UCT SPECIFICATIONS" section of this

manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT

Raise mower to its highest position. Measure height from bottom edge of mower to ground level at front corners of mower. Distance '_'on both sides of

mower should be the same.

If adjustment is necessary, make adjust-

ment on one side of mower only.

To raise one side of mower, tighten lift

link	adjustment		nut	on	that	side.
To lower one side of mower, loosen lift
link	adjustment		nut	on	that	side.
NOTE:	Each full		turn	of	adjustment			nut
will change		mower height about 3/16".
Recheck		measurements			after		adjusting.
Bottom	Edge	of				Bottom		Edge of
Mower	to Ground				Mower		to Ground

(_ Suspension

- \_:\-.............

AduJtstment

FRONT-TO-BACK ADJUSTMENT

IMPORTANT: Deck must be level side- to-side. If the following front-to-back adjustment is necessary, be sure to adjust both front links equally so mower will stay level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the

front tip is approximately 1/8" to 1/2" lower than the rear tip when the mower is in its ,_lLghest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

Check adjustment on right side of tractor. Position any blade so the tip is pointing straight forward. Measure distance "B" at front and rear tip of blade

Before making any necessary adjust- ments, check that both front plate links are equal in length.

If links are not equal in length, adjust one link to same length as other link. To lower front of blade, loosen nut "C" on both front links an equal number of turns.

NOTE: Each full turn of nut "C" will change distance "B" by approximately 3/16".

When distance "B" is 1/8" to 1/2" lower

at front than rear, tighten nut "D" against trunnion on both front links.

To raise front of blade, loosen nut "D" from trunnion on both front links.

Tighten nut "C" on both front links an equal number of turns. The two front links must remain equal in length.

•When distance "B" is 1/8" to 1/2" lower at front than rear, tighten nut "D" against trunnion on both front links.

•Recheck side-to-side adjustment.

22