INSTALL MOWER AND DRIVE
BELT
Be sure tractor is on level surface and
mower suspension arms are raised with attachment lift control. Engage parking brake.
1.Cut and remove ties securing anti- sway bar and belts, Swing
2.Slide mower under tractor with de-
flector shield to right side of tractor.
IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.
3.If equipped, turn height adjustment
knob counterclockwise until it stops.
4.Lower mower linkage with attachment lift control.
5.Install belt into electric clutch pulley groove,
6.Place the suspension arms on inward pointing deck pins. Retain with double
loop retainer spring with loops down as shown.
7.Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown.
8.Position front plate assembly between front mower brackets. Raise deck and
plate assembly to align holes and insert flanged pins, Secure pins with
double loop retainer springs between the plate and mower brackets.
NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower
IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves.
9.Connect
10.If equipped, turn height adjustment knob clockwise to remove slack from
mower suspension.
11.Raise deck to highest position.
12.Adjust gauge wheels before operating mower as shown in the Operation sec- tion of this manual.
| Chassis | Front Suspension | Electric | |
|
|
| ||
|
|
|
| |
| Bracket | Brackets | _ |
|
Double Loop |
| Front Mower |
| |
| Bracket |
| ||
|
|
| ||
Retainer Spring |
|
|
|
|
Gauge Wheel |
|
|
|
|
|
|
|
| Retainer Springs |
|
|
|
| • Front Plate |
|
|
|
| Assembly |
|
|
| "Flanged | |
|
|
| Pin | |
|
|
|
| |
USE PLIERS FOR |
|
|
|
|
RETAINER SPRINGS | Suspension |
|
| |
| Arms |
|
|
|
| [_ouble Loop |
|
| |
| Retainer | Spring |
|
|
wrl | t,inward pointing |
|
| |
| :leck pins) |
|
| |
10
